Gas tank lift on Mav

[imported_AGR071]

I did long ago a body lift but the gas tank needs lifting.
Any ideas as its held on at the front by 2 bolts and the brackets (welded to the tank) go flat towards the front for about 4 inches then they go down and backwards (at about a 30 degree angle basically till they rejoin the tank.
At the back they are basically flat.
I thought that if i droped the tank (using a jack),then put the back of the tank up first to bolt it in above the chassis,then put the front bolts back in.This would mean that the tank was on a angle and the gauge would read incorrect.

IS THIS THE WAY TO DO IT OR ARE THERE ANY BETTER IDEAS?

Thanks in advance

[imported_casper]

Do you have a picture of the tank?

I think I can visualise where you're talking about bat a piccy would be good.

[imported_AGR071]

Front of tank (if you can imagine)
http://i80.photobucket.com/albums/j169/AGR071/Frontoftank.jpg

Rear of tank
http://i80.photobucket.com/albums/j169/AGR071/Rearoftank.jpg

[imported_stormpatrol]

you should pull it all out and get a new system MR howard wants to give you a $1000.00 bonus for doing that :idea: :idea: :idea: isnt that FREAKY :P